Hello,
I am using SpamSieve as follows:
I have all of the domains I want to pass as good in the Allowlist. Usually “ends with…” then domain.
The blocklist simply contains the “@” text to match, since the program will check that after the allowlist.
This means that I only want known emails domains to pass into the inbox. Al of the rest are junk (or trash).
Here is the issue:
The same 3 sets of emails are consistently sent to the trash. All of the rest work fine. When I re-add these addresses to the Allowlist (this time as fill address rather than domain only), they still get sent to the trash a few minutes later.
Is there a way to tell why it is sending only these particular emails to the trash?
I have seen some changes in behavior recently, also, where more email is being sent to the Junk folder, rather than Trash.
I think I have all other options turned off.
Thank you in advance.
Mark